Photo Album: Basement Waterproofing and Mold Remediation in Tallahassee FL

The pump is actuated by a float.

Grounding rods

The building had previously been waterproofed, the sealant had deteriorated and failed. This was allowing water to infiltrate through the cinder block into the conditioned area.

The building had previously been waterproofed, the sealant had deteriorated and failed. This was allowing water to infiltrate through the cinder block into the conditioned area.

First, we dug trenches along the three of the exterior walls, thoroughly cleaned the walls and then applied HLM 5000 sealant.

We cleaned the newly exposed area of wall and foundation after digging trenches along exterior walls. After the debris and dirt are removed we are able to ensure that an applied waterproofing material will adhere directly to the exterior wall and footer.

This photo was taken after the dirt was filled back in and you can see some of the sealant. Later we added landscape to cover the area and add curb appeal.

Sump pump system during installation

A well was build at the lowest point and a sump pump was installed inside the well.

In the process of building an enclosure for the sump pump.

All finished wall/ceiling coverings were removed. Ductwork and insulation was also removed.